In the Paper Cassette
|
Before loading paper in the paper cassette, see "Attention (Loading Paper)."
|
1
Spread the paper guides a little wider than the paper size.
2
Gently load the paper stack into the paper cassette with the print side face up, until the edge of the paper stack meets the back of the paper cassette.
Make sure that the paper stack does not exceed the load limit guides (A).
When loading envelopes
|
(1)
|
Fold the envelope flap.
 |
|
(2)
|
Place the stack of envelopes on a flat surface, flatten them to release any remaining air, and make sure that the edges are pressed tightly.
 |
|
(3)
|
Loosen any stiff corners of the envelopes and flatten curls as shown in the figure.
 |
|
(4)
|
Align the edges of the envelopes on a flat surface.
 |
|
(5)
|
Gently load the envelopes into the paper cassette with the print side face up, until the edge of the envelope stack meets the back of the paper cassette.
|
3
Adjust the paper guides to the paper width without space.
|
IMPORTANT
|
Adjust the paper guides to the paper width without space.If the paper guides are too loose or too tight, this may result in misfeeds or paper jams.
 |
4
Adjust the rear paper guide to the paper length without space.
5
Pull out the output tray extension and lift the paper stopper.
6
Set the paper type loaded in the tray.