Setting the Punch Hole

With Document Binder, the punch hole settings for binder documents can be specified.

Note
When a Canon printer is selected and [Use print settings of Document Binder] is selected, these settings can be configured. The hole-punching setting is saved together with the binder document as the print setting information of the binder document. When the print location of the header/footer overlaps with the staple or hole punch position, adjust the print position by setting the gutter with the printer properties.

Note

When a Canon printer is selected and [Use print settings of Document Binder] is selected, these settings can be configured.

The hole-punching setting is saved together with the binder document as the print setting information of the binder document.

When the print location of the header/footer overlaps with the staple or hole punch position, adjust the print position by setting the gutter with the printer properties.

In addition, refer to the following as necessary.

Cautions and Restrictions

Select hole punching method from [Hole punch] in the [Print Settings] tab in the [Print Settings] pane.

The Preview Pane is updated.

Note
The Portrait position varies depending on the following settings. The printer selected in [Printer Name]. [Output Size] [Output Paper Orientation] [Binding Location] The setting in [Output Size], [Staple], and [Fold] may change the settings of [Hole punch] that have already been configured. When [Auto] is selected in [Output Size], [Hole punch] is changed to [Off]. If the gutter is set to less than 25/32 inch (20 mm), setting a hole punch causes a message to be displayed. Clicking [Yes] automatically sets the gutter to 25/32 inch (20 mm). Clicking [No] cancels the gutter setting.

Note

The Portrait position varies depending on the following settings.

The printer selected in [Printer Name].

[Output Size]

[Output Paper Orientation]

[Binding Location]

The setting in [Output Size], [Staple], and [Fold] may change the settings of [Hole punch] that have already been configured.

When [Auto] is selected in [Output Size], [Hole punch] is changed to [Off].

If the gutter is set to less than 25/32 inch (20 mm), setting a hole punch causes a message to be displayed. Clicking [Yes] automatically sets the gutter to 25/32 inch (20 mm). Clicking [No] cancels the gutter setting.