NetWare Network Setup Procedures

To use a NetWare network, it is necessary to perform the following procedures.

1 NetWare Print Service Settings

Specify the NetWare print service settings. (If you are using the imageRUNNER ADVANCE C350i/C250i, optional products are required to send a fax from a computer. For information on the optional products required to use this function, see "Optional Products Required for Each Function.") To specify the settings from the computer, use one of the following:

NWADMIN or PCONSOLE (Novell software provided with NetWare)

Canon utilities

2 Protocol Settings

Specify the protocol settings. To specify the settings, use one of the following:

The machine's control panel

The Remote UI (via a Web browser)

Canon utilities

3 Setting Up a Computer for Printing/Sending a Fax

Specify the settings of each computer you use for printing or sending a fax. (If you are using the imageRUNNER ADVANCE C350i/C250i, optional products are required to send a fax from a computer. For information on the optional products required to use this function, see "Optional Products Required for Each Function.")

IMPORTANT
It is recommended that you consult the administrator for the network you are using when performing the settings in steps 1 and 2. To configure settings with software other than the control panel of the machine, NWADMIN, or PCONSOLE, TCP/IPv4 protocol must be supported by your network environment (IPv6 is not supported).