Copying by Saving Paper

See "Attention (Combination of Copy Settings)" before you start copying.
Press [] (Paper Save Copy) to save paper when making a copy.
Choose one of the following four combinations of 2 on 1/4 on 1 and 2-Sided copy settings, as shown in the table below.
 
N on 1
2-Sided
Select Layout
Format Settings
Original Orientation
Original Format
2 on 1 1->2-Sided
1->2-Sided
Portrait
Book Type
4 on 1 1->2-Sided
1->2-Sided
Portrait
Book Type
2 on 1 1->1-Sided
OFF
4 on 1 1->1-Sided
OFF
IMPORTANT
Precautions on 2-Sided Copying
Do not touch your document when making 2-sided copying until the process is complete. After copying on the front side is complete, the document is partially output, reserved, and fed into the machine again for copying on the back side.
Be sure to close the sub-output tray before making 2-sided copying.
1
Set the paper switch lever correctly to fit the size of paper used for 2-sided copying.
If the lever is not set correctly, sheets may not be fed properly, or paper jams may occur.
1.
Open the lower rear cover.
2.
Securely place the blue color paper size switch lever (A).
A4:
Pull
Letter, Legal:
Push
3.
Close the lower rear cover.
2
Place your document.
3
Press [] (Paper Save Copy).
4
Select the combination that you want to use using [] or [] and press [OK].
5
Select the document size using [] or [] and press [OK].
6
Press [] (Start).
When the document is placed on the platen glass
(1)
Place the next page and press [] (Start).
* Repeat this step until all pages are scanned.
(2)
Select <Start Copying> using [] or [] and press [OK].
0H5S-053