Changing the Finisher Output Priority Settings (Thin)
When Thin paper (14 lb bond to 16 lb bond (52 g/m2 to 63 g/m2)) is used, you can give a priority to productivity or alignment for the output paper.
This mode can be set when the Staple Finisher-Q1 PRO or Booklet Finisher-Q1 PRO is attached. (See "Staple Finisher-Q1 PRO/Booklet Finisher-Q1 PRO/Puncher Unit-BS1.")
1.
Press 
(Settings/Registration).
(Settings/Registration).2.
Press [Adjustment/Maintenance] → [Adjust Action] → [Finisher Output Priority Settings (Thin)].
3.
Select [Productivity Priority] or [Alignment Priority] → press [OK].
Details of each item are shown below:
|
[Productivity Priority]:
|
This mode gives a priority to productivity. The output paper may not be aligned.
|
|
[Alignment Priority]:
|
As a priority is given to aligning the output paper, the production speed decreases compared with [Productivity Priority] mode.
|
|
NOTE
|
|
[Alignment Priority] is available only when outputting on Tray B of a finisher.
|