Use Cover Inserter

[Off]*, [Inserter 1], [Inserter 2] (If the Document Insertion Unit-K1 is attached)

This setting enables you to specify whether to add a cover at the front of the printed output.

[Off]

No cover is inserted at the front of the printed output.

[Inserter 1] or [Inserter 2]

A cover is inserted automatically at the front of the printed output. If used in combination with Staple settings, it is a handy function for arranging documents.

The paper to be used as the cover should be placed in the inserter.

Output Paper		[Inserter 1] or [Inserter 2]

		The gray sheets: Paper placed in the inserter

IMPORTANT
Nothing will be printed on the paper used for the cover. You cannot use this function in combination with 'Transparency Interleaving'. This function cannot be used if the 'Finishing' is set to [Off], [Collate], [Offset+Group], or [Staple+Group].

NOTE
This function is available for selection if the Document Insertion Unit-K1 is attached. This function can be used in combination with "Finishing," "Punch," or "Fold." You can place the following paper sizes and types in the Document Insertion Unit-K1: Paper sizes: 330 mm x 483 mm, 320 mm x 450 mm (SRA3), 305 mm x 457 mm, 11" x 17", LGL, LTR, LTRR, EXEC, A3, B4, A4, A4R, B5, B5R, and Custom Size (182 mm x 182 mm to 330.2 mm x 487.7 mm) Paper types: Thin, Plain, Recycled, Colour, Heavy, Letterhead, Bond, Tab, Pre-Punched, Tracing, Coated

NOTE

This function is available for selection if the Document Insertion Unit-K1 is attached.

This function can be used in combination with "Finishing," "Punch," or "Fold."

You can place the following paper sizes and types in the Document Insertion Unit-K1:

Paper sizes: 330 mm x 483 mm, 320 mm x 450 mm (SRA3), 305 mm x 457 mm, 11" x 17", LGL, LTR, LTRR, EXEC, A3, B4, A4, A4R, B5, B5R, and Custom Size (182 mm x 182 mm to 330.2 mm x 487.7 mm)

Paper types: Thin, Plain, Recycled, Colour, Heavy, Letterhead, Bond, Tab, Pre-Punched, Tracing, Coated