Quick Startup Settings

If you set the quick startup, you can reduce the time from turning ON the main power of the machine to starting operating the machine and scanning documents.

Press

Press [Preferences] → [Timer/Energy Settings] → [Quick Startup Settings for Main Power].

Press [On] → [OK].

If you do not set the quick startup, press [Off].

IMPORTANT
Even if this function is set to 'On', the machine does not startup quickly in the following situations: When the imagePASS is attached to the machine When any of the network settings below are set to 'On' RARP BOOTP IPsec IPv6 NetWare AppleTalk When turning ON the main power of the machine after turning OFF the main power in any of the conditions below More than 110 hours have elapsed after quick startup Operating jobs Jobs are reserved Just after using telephone lines Backing up data Accessing to the machine via network After specifying settings which require restarting the machine Error is occurred Using the Limited Functions mode The power cord is disconnected after turning OFF the main power MEAP applications which do not support quick startup are installed on the machine When turning ON the main power of the machine in 20 seconds after turning OFF the main power When turning ON the main power of the machine after turning OFF the main power from the Remote UI

IMPORTANT

Even if this function is set to 'On', the machine does not startup quickly in the following situations:

When the imagePASS is attached to the machine

When any of the network settings below are set to 'On'

RARP

BOOTP

IPsec

IPv6

NetWare

AppleTalk

When turning ON the main power of the machine after turning OFF the main power in any of the conditions below

More than 110 hours have elapsed after quick startup

Operating jobs

Jobs are reserved

Just after using telephone lines

Backing up data

Accessing to the machine via network

After specifying settings which require restarting the machine

Error is occurred

Using the Limited Functions mode

The power cord is disconnected after turning OFF the main power

MEAP applications which do not support quick startup are installed on the machine

When turning ON the main power of the machine in 20 seconds after turning OFF the main power

When turning ON the main power of the machine after turning OFF the main power from the Remote UI

NOTE
If you set the quick startup while the Sleep Mode Alert is set to 'On', the tone sounds when turning ON/OFF the main power of the machine. (Depending on the situations, the machine does not startup quickly and the tone does not sound.)