Changing the Finisher Output Priority Settings (Heavy 2,3)
When Heavy 2 (151 g/m2 to 220 g/m2) or Heavy 3 (221 g/m2 to 256 g/m2) paper is used, you can give a priority to productivity or alignment for the output paper.
This mode can be set only if the Staple Finisher-N1 or Booklet Finisher-N1 is attached. (See "Staple Finisher-N1/Booklet Finisher-N1/Puncher Unit-BG1/Puncher Unit-BH1/Inner Booklet Trimmer-A1.")
1.
Press 
.
.2.
Press [Adjustment/Maintenance] → [Adjust Action] → [Finisher Output Priority Settings (Heavy 2,3)].
3.
Select [Productivity Priority] or [Alignment Priority] → press [OK].
Details of each item are shown below:
|
[Productivity Priority]:
|
This mode gives a priority to productivity. The output paper may not be aligned.
|
|
[Alignment Priority]:
|
As a priority is given to aligning the output paper, the production speed decreases compared with [Productivity Priority] mode.
|