Paper Alignment on Finisher Tray A/B
You can adjust paper alignment when outputting on Tray A or B of a finisher.
This mode can be set when the Staple Finisher-Q1 PRO or Booklet Finisher-Q1 PRO is attached.
(See "Staple Finisher-Q1 PRO/Booklet Finisher-Q1 PRO/Puncher Unit-BT1/Puncher Unit-BU1.")
You cannot align output paper in the following situations:
when using paper smaller than A5R
when using different size paper together
If you set [Align Output Paper of Diff. Sizes (Diff. Width)] to 'On', you can align output paper by paper width.
(See "Aligning Output Paper of Different Width.")
1.
Press
.
2.
Press [Adjustment/Maintenance] → [Adjust Action] → [Finisher Tray A Alignment Adjustment] or [Finisher Tray B Alignment Adjustment].
3.
Press [-] or [+] to adjust the paper alignment → [OK].
NOTE
|
You can switch between positive and negative values by pressing [±].
|