Aligning Output Paper of Different Width

You can select whether to align the output paper by paper width when paper with different width is used for printing. If you set [Align Output Paper of Diff. Sizes (Diff. Width)] to [On], the machine automatically suspend the print job when paper with different width is output so that you can remove the output paper.
This mode can be set when the Finisher-AM1 or Saddle Finisher-AM2 is attached. (See "Finisher-AM1/Saddle Finisher-AM2/Puncher Unit-BS1/Puncher Unit-BT1.")
IMPORTANT
If you use paper smaller than STMTR, the output paper cannot be aligned.

1.
Press (Settings/Registration).
2.
Press [Function Settings] → [Common] → [Paper Output Settings].
3.
Press [Align Output Paper of Diff. Sizes (Diff. Width)].
4.
Select [On] or [Off] → press [OK].
Details of each item are shown below:
[On]:
Output paper is aligned by paper width when printing paper with different width. (When printing different size paper together, the available output destination is automatically selected.)
[Off]:
The output paper is not aligned by paper width when printing paper with different width.
NOTE
When [Align Output Paper of Diff. Sizes (Diff. Width)] is set to [On], printing stops temporarily if all of the available output trays have reached their stacking limits. If you remove the output paper from the trays, the trays move upward and printing resumes.
Even when [Align Output Paper of Diff. Sizes (Diff. Width)] is set to [Off], you can align output paper if you are using paper with the same width.
0L3X-07X