Loading Tab Paper Using the Tab Feeding Attachment Kit-B1 (Optional)

This section describes how to load tab paper in Paper Drawer 2 using the Tab Feeding Attachment Kit-B1.
IMPORTANT
Only A4 Tab Paper can be used.
NOTE
When you load tab paper, make sure to register the paper type. (See "Registering the Paper Size and Type for a Paper Source.")
If you want to insert printed tab paper as a chapter page, insert a blank paper where the tab paper will be inserted.

1.
Open the drawer.
1. Press and release the button on Paper Drawer 2.
2. Grip the handle, and pull out the paper drawer until it stops.
2.
Attach the Tab Feeding Attachment Kit-B1 to Paper Drawer 2.
1. Place the Tab Feeding Attachment Kit-B1 into the holes of the paper drawer.
2. Push it in as far as possible.
3.
Load the tab paper into the paper drawer.
Load the tab paper face up with the tabs to the left side, as shown in the illustration below.
IMPORTANT
Paper which has been rolled or curled must be straightened out prior to use.
Make sure that the height of the paper stack does not exceed the limit mark () at the back of the paper drawer.
4.
Squeeze the lever on the front guide, as shown in the illustration. While squeezing the lever, slide the front guide until it fits the tab paper.
* Front Guide
5.
Gently push the paper drawer back into the machine until it clicks into place in the closed position.
CAUTION
When returning the paper drawer to its original position, be careful not to get your fingers caught, as this may result in personal injury.
IMPORTANT
Never place paper or any other items in the open part of the paper drawer next to the paper stack. Doing so may cause a paper jam.
When you are not loading tab paper, make sure to remove the Tab Feeding Attachment Kit-B1 from the paper drawer. Using the Tab Feeding Attachment Kit-B1 for storing paper other than tab paper may cause a paper jam.
08RW-0H2