Remote UI
This mode enables you to use the Remote UI (User Interface) to operate the machine and change settings.
1.
Press 
.
. 2.
Press [Management Settings] → [License/Other] → [Remote UI].
3.
Press [On] → specify each setting.
If a screen prompting you to change a System Manager PIN is displayed, change a PIN by following the procedures described in "Specifying the System Manager Settings," and then set this function to 'On'.
Select [Off] → [OK] to disable the Remote UI.
Press [On] for <Use SSL> to use SSL communication.
Press [On] for <Use Reference Print> to allow printing by entering it URL.
|
NOTE
|
|
Before setting <Use SSL> to 'On', it is necessary to set a default key in [Preferences] (Settings/Registration). (See "Setting the Key Pair Used With SSL Encrypted Communications.")
Any changes made to <Use SSL> are also applied to [Use SSL] in [MEAP Settings] in [Management Settings] (Settings/Registration). (See "MEAP Settings.")
|
If Default Authentication is set as the login service and a System Manager ID is set without setting [Department ID Management]:
Specify each setting → press [Next].
Specify the settings related to the access of general users → press [OK].
Press [Allow] to allow access by general users, or [Do Not Allow] to not allow access by general users.
If you pressed [Allow] and you want to set a PIN, press [Access PIN] → set a PIN.
In other cases:
Specify each setting → press [OK].
|
NOTE
|
|
For more information on the Remote UI, see "Remote UI."
Changes are only effective after you restart the machine (the main power switch is turned OFF, and then back ON). For instruction on restarting (turning the main power switch OFF and then ON) the machine, see "Main Power and Energy Saver Key."
|