Replacing the Staple Cartridge (Staple Finisher-R1)
This section describes how to replace the staple case and staple cartridge in the stapler unit.
When the Staple Finisher-R1 is almost out of staples and the staple cartridge must be replaced, a screen prompting you to replace the staple cartridge appears on the touch panel display. Follow the procedure described below to replace the staple cartridge.
|
NOTE
|
|
The Staple Finisher-R1 is an optional product.
We recommend that you order staple cartridges from your local authorized Canon dealer before your stock runs out.
Use only staple cases intended for use with this machine.
|
1.
Open the front cover of the finisher.
2.
Grasp the staple case by the green tab to pull it out from the stapler unit.
* Staple Case
3.
Squeeze and lift the empty staple cartridge by its sides marked with arrows to remove it from the staple case.
|
NOTE
|
|
You can lift the staple cartridge only when no staples are left inside the cartridge.
|
4.
Insert a new staple cartridge into the staple case.
|
IMPORTANT
|
|
Use only staple cartridges designed for use with this machine. (See "Consumables.")
Only one staple cartridge can be inserted at a time.
Make sure that you pull the seal straight out. If you pull it out at an angle, it may tear.
|
5.
Return the staple case to its original position in the stapler unit.
6.
Close the front cover of the finisher.
 CAUTION |
|
When closing the front cover of the finisher, be careful not to get your fingers caught, as this may result in personal injury.
|
|
NOTE
|
|
After the cover is closed, the stapler unit may automatically perform a "dry" stapling operation to reposition the staples.
|