Interrupt Mode
The interrupt mode enables you to pause a reserved or current job to make higher priority copies. This mode is useful if you need to make a rush copy during a long copy job.
To use the interrupt mode while waiting for print job to finish, press 
(Status Monitor/Cancel) → [Copy/Print] → [Job Status] → [Interrupt/Priority Print]. (See "Checking and Cancelling Copy/Print Jobs .")
(Status Monitor/Cancel) → [Copy/Print] → [Job Status] → [Interrupt/Priority Print]. (See "Checking and Cancelling Copy/Print Jobs .")1.
Press [Copy].
2.
Press [Interrupt].
To change the Department ID before copying, press 
(Log In/Out) → enter the Department ID and PIN using 
- 
(numeric keys). (See "Entering the Department ID and PIN.")
(Log In/Out) → enter the Department ID and PIN using - (numeric keys). (See "Entering the Department ID and PIN.")|
NOTE
|
|
Pressing [Interrupt] does not immediately stop the current job. Printing of the current job stops only when the actual printing of the priority or interrupt copy starts.
|
3.
Set the desired copy modes.
4.
Press 
(Start).
(Start).|
IMPORTANT
|
|
If you want to continue making interrupt copies, wait until the current interrupt copy job is complete. Then, repeat steps 2 to 3.
|
|
IMPORTANT
|
|
For information on the modes which cannot be set in combination with this mode, see "Unavailable Combination of Functions."
|
|
NOTE
|
|
You cannot make interrupt copies if there is an interrupt copy job being processed or waiting to be processed.
To cancel the interrupt mode, press [Interrupt].
|