Logging In to the User Management Page

To specify each setting for [User Access Control for Advanced Space], it is necessary to access and then log in to the machine from a Web browser. This section describes the procedure for accessing the machine from the portal page of the Remote UI.
IMPORTANT
Only the Advanced Space administrator can register a user. The following are the default settings for the user name and password for the Advanced Space administrator. We recommend that you change both the user name and password.
User Name: Administrator
Password: password
To use [User Access Control for Advanced Space], set [Use HTTP] in [Preferences] (Settings/Registration) to 'On.' (See "Settings Common to TCP/IPv4 and TCP/IPv6.")
To use the Remote UI, set [Remote UI] in [Management Settings] (Settings/Registration) to 'On'. (See "Remote UI.")

1.
Start your Web browser → enter the following URL in the address bar.
http://<IP address of the machine or host name>
NOTE
You can also log in by entering the URL of [User Access Control for Advanced Space] in the address bar, as indicated below. (Case sensitive.)
http://<IP address or host name of the machine>:8000/uactrl/
2.
If you are logging in as an administrator, select [System Manager Mode] → enter the System Manager ID and System Manager PIN →click [Log In]. If you are a general user, select [General User Mode] → enter PIN → click [Log In].
If the Department ID Management or authentication for SSO-H is set, enter the necessary items for each log in.
3.
Click [User Access Control for Advanced Space] from the Basic Tools.
4.
Enter the user name and password for Advanced Space administrator → click [Log In].
IMPORTANT
The following are the default settings for the user name and password for the Advanced Space administrator. We recommend that you change both the user name and password.
User Name: Administrator
Password: password
NOTE
Click [Log Out from User Access Control] to finish the operation. If you close the Web browser page without clicking [Log Out from User Access Control], the logout process will not be performed correctly. In this case, note that you will not be able to log in again for approximately 30 minutes.
08KL-20A