Setting the Line to Use when Sending
You can register the method for selecting the line to use for sending. You can also set to prohibit sending from a line.
For information on the optional products required to use this function, see "Optional Products Required for Each Function."
|
NOTE
|
|
You can use this mode if the Super G3 2nd Line Fax Board is added to the Super G3 FAX Board.
|
1.
Press 
(Settings/Registration).
(Settings/Registration).2.
Press [Function Settings] → [Send] → [Fax Settings].
3.
Press [Set Line] → [Select TX Line].
4.
Specify each setting → press [OK].
Details of each item are shown below:
|
[Priority TX]:
|
The line specified in [Priority TX] is selected to send if the line is not in use.
|
|
[Prohibit TX]:
|
The line specified in [Prohibit TX] is restricted. (The specified line is used only for receiving.)
|
Depending on the fax board installed, the lines that you can select vary as shown below:
If only the Super G3 FAX Board is installed: Line 1
If the Super G3 FAX Board and Super G3 2nd Line Fax Board are installed: Line 1, Line 2
If the Super G3 FAX Board, Super G3 2nd Line Fax Board, and Super G3 3rd/4th Line Fax Board are installed: Line 1, Line 2, Line 3, Line 4
|
IMPORTANT
|
|
You cannot set both [Priority TX] and [Prohibit TX] for the same line.
Set one single line for [Priority TX]. You cannot set all lines to [Prohibit TX].
Even if you set to prohibit using [Line1] for sending documents, [Line1] is still used for fax information services.
|
|
NOTE
|
|
If you select another line in [Options], that setting takes priority.
|