Recalling Previous Settings and Sending a Fax

You can recall the three most recent destinations, scan settings, or send settings.

Press [Fax] → [Previous Settings].

Select the settings to recall → press [OK].

NOTE
You can change the settings for a recalled send job. If there are multiple destinations stored in one log, the order of the destinations shown in the list may not correspond to the order in which they were set.

IMPORTANT
Send settings are counted as single recent send settings until the following times: When you press the control panel power switch When you press When you press When the Auto Clear mode activates When the Auto Sleep time has elapsed If you set [Manage Address Book Access Numbers] to 'On', you cannot recall settings from memory. (See "Managing the Address Book with Access Numbers.") If you set any address type to 'On' in [Limit New Destination], the currently stored Previous Settings are deleted. (See "Restricting Sending to New Addresses.")

IMPORTANT

Send settings are counted as single recent send settings until the following times:

When you press the control panel power switch

When you press

When the Auto Clear mode activates

When the Auto Sleep time has elapsed

If you set [Manage Address Book Access Numbers] to 'On', you cannot recall settings from memory. (See "Managing the Address Book with Access Numbers.")

If you set any address type to 'On' in [Limit New Destination], the currently stored Previous Settings are deleted. (See "Restricting Sending to New Addresses.")

NOTE
The three most recent settings that were stored in memory are not deleted even when the main power is turned OFF.