Inner 2 Hole Puncher-A1/Inner 2/3 Hole Puncher-A1/Inner 2/4 Hole Puncher-A1
When the punch waste tray of the Puncher becomes full, a screen prompting you to remove the punch waste appears on the touch panel display.
Follow the procedure described below to remove the punch waste.
|
NOTE
|
|
The Inner 2 Hole Puncher-A1, Inner 2/3 Hole Puncher-A1, and Inner 2/4 Hole Puncher-A1 are optional products.
The Inner 2 Hole Puncher-A1/Inner 2/3 Hole Puncher-A1/Inner 2/4 Hole Puncher-A1 is available only if the Inner Finisher-D1 is attached.
|
1.
Pull out the punch waste tray.
 |
1. Open the front cover of the inner finisher. |
2. Pull out the punch waste tray. |
2.
Discard the punch waste.
|
NOTE
|
|
Make sure that the punch waste tray is completely emptied.
|
3.
Return the punch waste tray to its original position.
 |
1. Push the punch waste tray back into its original position. |
2. Close the front cover of the inner finisher. |
 CAUTION |
|
When closing the cover, be careful not to get your fingers caught, as this may result in personal injury.
|
|
NOTE
|
|
If the punch waste tray is not securely in place, you cannot make prints in the Hole Punch mode.
|