Attention (Setting the IPv6 Address)

IMPORTANT
IPv6:
You cannot only use IPv6 without using IPv4.
Encryption by IPsec (Security Architecture for Internet Protocol) is not supported.
Addresses that you cannot enter in [IP Address] and [Default Router Address].
Multicast address (address that starts with "ff")
Address that consists of all zeros.
NOTE
IPv6 address:
This machine can have up to nine of the following IPv6 addresses (only one address can be registered manually). In IPv6 communication, multiple IPv6 addresses can be used at the same time.
Type
Registrable number
Overview
Link-Local Address
1
A link local address is automatically set using the specific prefix (information indicating the network the machine belongs to) "fe80::" and an interface identifier generated from the MAC address of this machine.
Because a link local address is valid only within the same prefix, it cannot traverse the router. When the machine is using the IPv6, one link local address is always set.
Manual Address
0 or 1
A fixed address that you enter manually. If you want to set the IP address manually, you can specify the prefix length or the default router address.
Stateless Address
0 to 6
A stateless address is automatically set using the machine's MAC address and the prefix (information indicating the network the machine belongs to) included in the RA (Router Advertisement) notified by the router.
Stateful Address
0 or 1
A stateful address can be obtained from a DHCP server using DHCPv6.
Stateless Address:
When restarting the machine (when the power is turned on), the stateless address is erased.
0880-09W