The Toner Does Not Fix onto the Paper Well

Perform one of the following solutions according to the cause.

<Cause 1> The setting for [Paper Type] is not specified properly.

Solution
Specify [Paper Type] properly.

<Cause 2> Appropriate paper is not being used.

Solution
Replace the paper with that which can be used with this printer.

<Cause 3> Toner may not fix onto paper completely depending on the paper type.

Solution
Perform the following procedure in the printer driver.
UFR II Printer Driver
1.
Display the [Quality] tab.
2.
Click [Details].
3.
Click [Advanced Settings] in the [Detailed Settings] dialog box.
4.
Set [Gray Compensation] to [On].
PCL/PS Printer Driver
See Help of the PCL/PS printer driver.
You can specify the same setting from the printer's control panel.

<Cause 4>Toner on the parts dense in color does not fix onto the paper.

Solution
Set [Special Image Mode] to [Level 1].
If the problem still persists, set it to [Level 2].
Normally, set [Special Image Mode] to [Off]. Do not set [Level 1] or [Level 2] unless the problems described above occur.
If [Special Image Mode] is set to [Level 1] or [Level 2], the print density may be lower than if it was set to [Off].

<Cause 5>A problem is occurring inside the printer.

Solution
If <Ennn-nnnn> appears in the display, follow the procedure in "The Message Indicator Is On" to solve the problem.
07E3-0KJ