Removing the Packing Materials

NOTE
Store the removed packing materials. They are required when transporting the printer for relocation or maintenance. About the packing materials The packing materials may be changed in form or placement, or may be added or removed without notice.

NOTE

Store the removed packing materials.

They are required when transporting the printer for relocation or maintenance.

About the packing materials

The packing materials may be changed in form or placement, or may be added or removed without notice.

Remove all the orange tape if it is attached to the printer when performing the following procedure.

Open the front cover while pressing the open button.

Take out the toner cartridge from the protective bag.

You can open the protective bag with your hands from the notch.

Keep the protective bag. Do not discard it. You will need it when you remove the toner cartridge for printer maintenance or other purposes.

Shake the toner cartridge five or six times as shown in the figure to evenly distribute the toner inside the cartridge.

Place the toner cartridge on a flat surface.

Fold the tab, and then pull out the sealing tape (approx. 20 in. (50 cm)).

IMPORTANT
Precautions when pulling out the sealing tape Do not pull the sealing tape diagonally, upward, or downward. If the tape is severed, this may become difficult to pull out completely. If the sealing tape stops at midpoint, pull it out of the toner cartridge completely. If any tape remains in the toner cartridge, this may result in poor print quality. Dispose of the removed sealing tape according to local regulations.

IMPORTANT

Precautions when pulling out the sealing tape

Do not pull the sealing tape diagonally, upward, or downward. If the tape is severed, this may become difficult to pull out completely.

If the sealing tape stops at midpoint, pull it out of the toner cartridge completely. If any tape remains in the toner cartridge, this may result in poor print quality.

Dispose of the removed sealing tape according to local regulations.

Install the toner cartridge.

Push the toner cartridge into the printer firmly until it touches the back of the printer while aligning (A) on both sides of the toner cartridge with the toner cartridge guides inside the printer.

Close the front cover.

If you cannot close the front cover

Make sure that the toner cartridge is installed in the printer properly. Do not try to forcefully close the front cover, as this may damage the printer.

Pull out the paper drawer.

Remove the packing material as shown in the figure.

(1)	Remove the tape, and fold the protrusions of the packing material on each side.
(2)	While holding the lock release levers (A), slide the paper guides in the directions of the arrows.
(3)	Remove the packing material.

Insert the paper drawer into the printer.

Push it into the printer firmly.

Check !

Checking if the packing materials are removed

Check that the following packing materials are completely removed.

Dispose of the left packing materials according to local regulations.

*	Make sure that all the orange tape is completely removed.

Close the covers after you finish checking.

Next, perform one of the following procedures.

	If you want to use the printer with optional accessories installed Install the optional accessories before installing the printer. "Installing the Paper Feeder" "Installing ROM" "Installing SD Card"

	If you want to use the printer without optional accessories installed Install the printer. "Installing the Printer"