Performing the Configuration Using the Printer's Control Panel (the Settings to Be Performed First)

When configuring the startup waiting time using the printer's control panel, use the following menu hierarchy.

Pressing [ ] (Settings) displays the common Setup menu.
indicates that the procedure is performed by pressing [ ] or [ ] on the control panel.
indicates that the procedure is performed by pressing [OK] on the control panel.

IMPORTANT
After performing the configuration To enable the settings, perform a hard reset or restart the printer. For details on a hard reset, see "Canceling All the Jobs (Hard Reset)." To go back up the hierarchy Press [ ] (Back). About the control panel For details on the control panel, see "Control Panel."

IMPORTANT

After performing the configuration

To enable the settings, perform a hard reset or restart the printer.

For details on a hard reset, see "Canceling All the Jobs (Hard Reset)."

To go back up the hierarchy

Press [ ] (Back).

About the control panel

For details on the control panel, see "Control Panel."

Press [ ] (Settings), select [Std Network Menu] using [ ] and [ ], and then press [OK].

When the message is displayed, press [OK].

You can specify the settings when the printer is either online (the Online indicator is on) or offline (the Online indicator is off).

Select [Start Wait Time] using [ ] and [ ], and then press [OK].

Specify the setting for startup waiting time using [ ] and [ ], and then press [OK].

Normally, you do not need to change the setting for startup waiting time (the time from when you turn the printer ON to when the printer starts communication). Specify the setting for the startup waiting time only when the printer cannot be connected to the network.

NOTE
If this printer is connected to a switching hub etc. The printer may not be able to be connected to the network even when the network settings are correct. This is because the printer and hub cannot communicate each other immediately after this printer is connected to the hub due to a spanning tree process. In this case, you need to make this printer wait to start communication. For details on the functions of a switching hub, contact the manufacturer of the switching hub.

NOTE

If this printer is connected to a switching hub etc.

The printer may not be able to be connected to the network even when the network settings are correct. This is because the printer and hub cannot communicate each other immediately after this printer is connected to the hub due to a spanning tree process.

In this case, you need to make this printer wait to start communication. For details on the functions of a switching hub, contact the manufacturer of the switching hub.

Perform a hard reset or restart the printer.

After performing a hard reset or restarting the printer, the settings are effective.

NOTE
For details on a hard reset See "Canceling All the Jobs (Hard Reset)."