[Setup] Menu ([Interface Menu] Options)

NOTE
Table description
Bold values in the table indicate the default settings.
After changing the setting items with "*1", cycle the power of the printer or perform a hard reset to make the settings effective.
The setting items or setting values with "*2" may not be displayed depending on the availability of the optional accessories and other settings.
Setting Item
Setting Value
Setting
[Interface Connection]*1
[USB]: [Off], [On]
[Network]: [Off], [On]
Specifies the settings for the interfaces used for communication with the computer and so on.
You can specify [On] or [Off] for each interface.
[Mode Timeout]
[Mode Timeout]: [Off], [On]
[Time]: 5 to 15 to 300 seconds
Specifies the function to finish a job automatically.
[Extension Card]*2
-
This is the setting for the interface board installed in the expansion slot of the printer. This item is displayed only when the interface board is installed. For more details, see the instruction manual supplied with the interface board.
[Connection Recog.]*1
[Off], [On]
When you print using the standard network, you may not obtain proper printout results. (Unreadable characters are printed, overlay printing fails, etc.) In this case, specify [Off] for this item.
[Extended RX Buffer]*1*2
[Off], [On]
If this item is set to [On], the memory capacity of the printer's receive buffer that receives the data is increased. You can speed up the time the computer exits when you send a large amount of data or complicated data from the computer.
0032-0WY