Changing the Settings Using Web Browser (Remote UI)

1
Start the Remote UI, and then log in as Administrator.
2
Select [Network] from the [Device Manager] menu.
3
Click [Ethernet Driver Setting].
4
Configure the Ethernet driver.
(1)
Select an Ethernet type.
This printer can detect the communication method and Ethernet type automatically. Normally, select [Auto Detect].
If you want to fix the communication method and Ethernet type, configure the Ethernet driver manually.
If you set the Ethernet type to [10 Base-T (Half Duplex) or [100 Base-TX (Half Duplex)] manually, data is received and transmitted alternately, not simultaneously. If you set the Ethernet type to [10 Base-T (Full Duplex) or [100 Base-TX (Full Duplex)], data is received and transmitted simultaneously.
(2)
Click [OK].
5
Perform a hard reset or restart the printer.
After performing a hard reset or restarting the printer, the settings are effective.
NOTE
To perform a hard reset
You can perform a hard reset using the following procedure.
1.
Select [Status] from the [Device Manager] menu.
2.
Click [Device Control].
3.
Select [Hard Reset], then click [Execute].
0038-06E