Changing the Settings Using Web Browser (Remote UI)

1
Start the Remote UI, and then log in as Administrator.
2
Select [Network] from the [Device Manager] menu.
3
Click [Change] under [Startup Time].
4
Specify the setting for startup waiting time.
Normally, you do not need to change the setting for startup waiting time (the time from when you turn the printer ON to when the printer starts communication). Specify the setting for the startup waiting time only when the printer cannot be connected to the network.
(1)
Enter the startup waiting time from when you turn the printer ON to when the printer starts communication (0 to 300 seconds).
(2)
Click [OK].
NOTE
If this printer is connected to a switching hub etc.
The printer may not be able to be connected to the network even when the network settings are
correct. This is because the printer and hub cannot communicate each other immediately after this
printer is connected to the hub due to a spanning tree process.
In this case, you need to make this printer wait to start communication. For details on the functions
of a switching hub, contact the manufacturer of the switching hub.
5
Perform a hard reset or restart the printer.
After performing a hard reset or restarting the printer, the settings are effective.
NOTE
To perform a hard reset
You can perform a hard reset using the following procedure.
1.
Select [Status] from the [Device Manager] menu.
2.
Click [Device Control].
3.
Select [Hard Reset], then click [Execute].
0038-06J