Installing Wireless Network Interface Board NB-W2
Installing NB-W2
Install NB-W2 in the expansion slot of the printer unit using the following procedure.
|
Before installing NB-W2, see "Attention (Printer Installation)."
|
|
NOTE
|
Parts and Functions of NB-W2See "Parts and Functions of NB-W2".
A Phillips screwdriver is required.Have a screwdriver ready that matches the size of the screws.
|
1
Turn the printer OFF, then disconnect the cables or cords from the printer.
|
|
Shut down the printer before turning it OFF.
For details on the procedure for shutting down the printer, see "Turning the Printer ON/OFF." |
<How to disconnect the cable or cord>
|
USB cable*
|
(2) Turn the computer OFF.
(3) Disconnect the cable from the printer.
|
|
LAN cable*
|
(4) Disconnect the cable from the printer.
|
|
Power cord
|
(5) Disconnect the power plug from the AC power outlet.
(6) Disconnect the cord from the printer.
|
|
*
|
Whether the cable is connected or not varies depending on your environment.
|
2
Remove the screws and remove the protective plate for the expansion slot.
3
Rotate the antenna to the position shown in the figure.
4
Insert NB-W2 into the expansion slot.
Hold NB-W2 by the top and bottom, and then insert NB-W2 firmly while aligning it with the guide rails inside the expansion slot.
5
Secure the top and bottom of NB-W2 with the two screws supplied with NB-W2.
Angle the antenna upward after securing it with the screws.
6
Connect the removed cables and cords to the printer.
<How to connect the cable or cord>
|
USB cable*
|
Connect to the USB connector on the printer.
|
|
Power cord
|
(1) Plug the power cord to the power socket on the printer.
(2) Plug the power plug into the AC power outlet.
|
|
*
|
Whether the cable is connected or not varies depending on your environment.
|