Registering the Paper Size and Type

This printer cannot automatically detect the paper size. Therefore, you need to register the size of the loaded paper.

Also, it is necessary to set the paper type to match the type of paper that is loaded.

NOTE
Precautions when specifying [Mixed Sizes] The printer performs printing without checking the paper settings in the printer driver. Make sure that the paper specified in the printer driver matches that loaded in the paper drawer before using the printer. If you are using the UFR II printer driver, load custom size paper whose long edges are 8.50 in. (215.9 mm) or less in landscape orientation.

Press [

] (

Feeder Selection).

Select the paper source whose size is to be registered using [

] and [

], and press [OK].

Select either [MP Tray Paper Size], [Drawer 1 Size] or [Drawer 2 Size].

Select a paper size using [

] and [

], and then press [OK].

→	Paper size is registered.

Select the paper source whose type is to be registered using [

] and [

], and press [OK].

Select either [MP Tray Paper Type], [Drawer 1 Type] or [Drawer 2 Type].

Since the printer driver's [Paper Type] default value is [Printer Default], it is normally not necessary to change the printer driver settings.
Whenever you change the printer driver settings, match them with the paper settings on the control panel.

Select the paper type with [

] or [

], and then press [OK].

→	The paper type is registered.

Next, specify the following settings.

		When printing from the printer driver on Windows or Macintosh, configure the printer driver.
		"Configuring the Printer Driver and Printing"

		When printing from DOS or UNIX, specify the settings for [Standard Paper Size] and [Default Paper Type] using the control panel.
		"[Setup] Menu ([Paper Source] Options)"

Registering the Paper Size and Type

Precautions when specifying [Mixed Sizes]