Enabling the Remote UI

This section describes the procedure for enabling the Remote UI using the printer's control panel.
NOTE
When enabling the Remote UI using software other than the Remote UI
You can also enable the Remote UI using the following software.
You can enable the Remote UI by accessing the FTP server of the printer using Command Prompt.
1
Press [  ] (Settings), select [Network] using [ ] and [ ], and then press [OK].
When the message is displayed, press [OK].
2
Select [Remote UI Settings] using [ ] and [ ], and then press [OK].
3
Select [Remote UI] using [ ] and [ ], and then press [OK].
4
Select [On] using [ ] and [ ], and then press [OK].
5
Perform a hard reset or restart the printer.
After performing a hard reset or restarting the printer, the settings are effective.
NOTE
For details on a hard reset
0264-086