|
NOTE
|
Table descriptionBold values in the table indicate the default settings.
After changing the setting items with "*1", cycle the power of the printer or perform a hard reset to make the settings effective.
The setting items or setting values with "*2" may not be displayed depending on the availability of the optional accessories and other settings.
|
|
Setting Item
|
Setting Value
|
Setting
|
|
[Interface Selection]*1
|
Specifies the settings for the interfaces used for communication with the computer or other device.
|
|
|
[USB]
|
[Use USB Connection]: [Off], [On]
[Recog. USB Connect.]:
[Mode 1], [Mode 2] |
[Use USB Connection]
Specifies whether to use the USB interface.
[Recog. USB Connect.]
Switches the USB connection recognition mode.
Normally, set it as [Mode 1]. |
|
[Network]
|
[Off], [On]
|
Specifies whether to use the network interface.
|
|
[USB Storage Device]
|
[MEAP Driver]: [Off], [On]
|
Specifies the setting for the device driver when using USB memory devices.
|
|
[Timeout]
|
[Timeout]: [Off], [On]
[Timeout Time]: 5 to 15 to 300 seconds
|
Specifies the function to finish a job automatically.
|
|
[Connection Recog.]*1
|
[Off], [On]
|
When you print using the standard network, you may not obtain proper printout results. (Unreadable characters are printed, overlay printing fails, etc.) In this case, specify [Off] for this item.
|
|
[Extended RX Buffer]*1*2
|
[Off], [On]
|
If this item is set to [On], the memory capacity of the printer's receive buffer that receives the data is increased. You can speed up the time the computer exits when you send a large amount of data or complicated data from the computer.
|