The Toner Does Not Fix onto the Paper Well

<Cause 1> The setting for [Paper Type] is not specified properly.

<Cause 2> Appropriate paper is not being used.

<Cause 3>Depending on the paper type, toner fixation may deteriorate.

Solution 1	UFR II Printer Driver Perform the following procedure in the printer driver. 1. Display the [Quality] sheet. 2. Click [Advanced Settings]. 3. Set [Gray Compensation] to one of the following Images Only Text and Images Graphics and Images All PCL/PS Printer Driver See Help of the PCL/PS printer driver. You can specify the same setting from the printer's control panel. "[Setup] Menu ([Quality] Options)"
Solution 2	Perform the following procedure in the printer driver. 1. Display the [Paper Source] sheet. 2. Set [Paper Type] to one of the following settings. Currently Selected Setting Setting to be Selected [Plain L2] [Plain L] [Plain L] [Plain] [Plain] [Plain H] [Plain H] [Heavy 1] [Heavy 1] [Heavy 2] [Heavy 2] [Heavy 3] [Envelope] [Envelope H] [Coated 1] [Coated 2] [Coated 2] [Coated 3] [Coated 3] [Coated 4] When the settings are changed, sometimes residual images appear on non-printed areas.
Solution 3	Perform the following procedure. 1. Press [  ] (: Online). 2. Select [Special Print Mode] in [User Maintenance]. 3. Set [Rough Paper Adj.] to [On].

<Cause 4> Toner does not fix to the paper in places with high density.

Solution

Set [Special Image Mode] to [Level 1]. If the problem still persists, set it to [Level 2]. "[Setup] Menu ([User Maintenance] Options)" Normally, set [Special Image Mode] to [Off]. Do not set [Level 1] or [Level 2] unless the problems described above occur. If it is set to [Level 1] or [Level 2], the print density may be lower than if it was set to [Off].

<Cause 5> A problem is occurring inside the printer.