Loading Envelopes and Custom Paper Sizes

NOTE
When loading envelopes and custom paper sizes in the multi-purpose tray Load them the same way as standard size paper. "Loading Paper in the Multi-purpose Tray"

Loading Envelopes and Custom Paper Sizes in the Paper Drawer

	For details on the paper that you can load in the drawer, see "Usable Paper."
	Load paper in Drawer 2 (optional) in the same manner as you load paper in Drawer 1.

Before loading paper, see "Attention (Drawer)."

Pull out the drawer.

Slide the paper guides a little wider and longer than the actual paper size.

While holding the lock release lever (A), adjust the guides.

When loading paper that is longer than A4 size

Pull out the drawer.

Load the paper with the printing side facing up so that the edges of the stacked paper are aligned with the rear side of the drawer.

IMPORTANT
About the paper loading orientation If you are not using the UFR II printer driver, load paper in portrait orientation. Also, be sure to load paper in landscape orientation if all the following conditions are fulfilled. You are using the UFR II printer driver. [Drawer 1 Size] and [Drawer 2 Size] are set to [Mixed Sizes]. Custom size paper whose long edges are 215.9 mm or less is loaded. When loading envelopes See "Printing on Envelopes" and load the paper in the proper orientation.

IMPORTANT

About the paper loading orientation

If you are not using the UFR II printer driver, load paper in portrait orientation.
Also, be sure to load paper in landscape orientation if all the following conditions are fulfilled.

You are using the UFR II printer driver.

[Drawer 1 Size] and [Drawer 2 Size] are set to [Mixed Sizes].

Custom size paper whose long edges are 215.9 mm or less is loaded.

When loading envelopes

See "Printing on Envelopes" and load the paper in the proper orientation.

NOTE
When loading paper with a letterhead or logo See "Paper Loading Orientation" and load the paper in the correct orientation.

Align the paper guides with the loaded paper.

While holding the lock release lever (A), adjust the guides.

IMPORTANT
Be sure to align the paper guides with the paper. If the paper guides are too loose or too tight, this may result in misfeeds or paper jams.

Make sure that the paper stack does not exceed the load limit mark lines (A).

Be sure that the paper stack does not exceed the load limit mark lines. If the paper stack exceeds the load limit mark lines, this may result in misfeeds.

Set the drawer in the printer.

NOTE
When paper is loaded that is longer than A4 size When the paper drawer is inserted with it extended, the front side of the paper drawer is not flush with the front surface of the printer as shown in the following figure.

Next, register the paper size and type.

"Registering the Paper Size and Type"

Loading Envelopes and Custom Paper Sizes

When loading envelopes and custom paper sizes in the multi-purpose tray