Performing the Configuration Using the Printer's Control Panel (When You First Set it Up)
When configuring the interface using the printer's control panel, use the following menu hierarchy.
|
*1
|
[Communication Mode] and [Ethernet Type] are displayed when [Auto Detect] is set to [Off].
|
|
*2
|
[Communication Mode] appears only when [Ethernet Type] is set to a setting other than [1000 Base-T].
|
Pressing [ 
] (
: Settings) displays the common Setup menu.
indicates that the procedure is performed by pressing [ 
] or [ 
] on the control panel.
indicates that the procedure is performed by pressing [OK] on the control panel.
] (: Settings) displays the common Setup menu. indicates that the procedure is performed by pressing [ ] or [ ] on the control panel. indicates that the procedure is performed by pressing [OK] on the control panel.|
IMPORTANT
|
After performing the configurationTo enable the settings, perform a hard reset or restart the printer.
For details on a hard reset, see "Canceling All the Jobs (Hard Reset)." To go back up the hierarchyPress [
 ] ( : Back). About the control panelFor details on the control panel, see "Control Panel."
|
1
Press [ ] (: Settings), select [Network] using [ ] and [ ], and then press [OK].
] (: Settings), select [Network] using [ ] and [ ], and then press [OK]. When the message is displayed, press [OK].
 |
You can specify the settings when the printer is either online (the
 (Online) indicator is on) or offline (the (Online) indicator is off). |
2
Select [Ethernet Driver] using [ ] and [ ], and then press [OK].
] and [ ], and then press [OK].3
Configure the Ethernet driver.
|
|
This printer can detect the communication method and Ethernet type automatically. Normally, set [Auto Detect] to [On].
If you want to fix the communication method and Ethernet type, set [Auto Detect] to [Off]. |
|
|
If you are using a hub, match the settings for the hub and the printer. For the settings of the hub you are using, consult your network administrator.
|
(Example)
Hub settings
Communication mode: Full duplex
Ethernet type: 10 Base-T
Printer settings
[Auto Detect]: [Off]
[Communication Mode]: [Full Duplex]
[Ethernet Type]: [10 Base-T]
When detecting the Ethernet driver automatically (Default)
|
(1)
|
Select [Auto Detect] using [
] and [ ], and then press [OK]. |
|
(2)
|
Select [On] using [
] and [ ], and then press [OK]. |
When detecting the Ethernet driver manually
|
(1)
|
Select [Auto Detect] using [
] and [ ], and then press [OK]. |
||||
|
(2)
|
Select [Off] using [
] and [ ], and then press [OK]. |
||||
|
(3)
|
Select [Communication Mode] using [
] and [ ], and then press [OK]. |
||||
|
(4)
|
Select an Ethernet communication method appropriate for your network environment using [
] and [ ], and then press [OK].
|
||||
|
(5)
|
Select [Ethernet Type] using [
] and [ ], and then press [OK]. |
||||
|
(6)
|
Select an Ethernet type appropriate for your network environment using [
] and [ ], and then press [OK]. |
4
Perform a hard reset or restart the printer.
After performing a hard reset or restarting the printer, the settings are effective.
|
NOTE
|
For details on a hard reset |