Performing the Configuration Using the Printer's Control Panel
When configuring the startup waiting time using the printer's control panel, use the following menu hierarchy.
Pressing [ 
] (
: Settings) displays the common Setup menu.
indicates that the procedure is performed by pressing [ 
] or [ 
] on the control panel.
indicates that the procedure is performed by pressing [OK] on the control panel.
] (: Settings) displays the common Setup menu. indicates that the procedure is performed by pressing [ ] or [ ] on the control panel. indicates that the procedure is performed by pressing [OK] on the control panel.|
IMPORTANT
|
After performing the configurationTo enable the settings, perform a hard reset or restart the printer.
For details on a hard reset, see "Canceling All the Jobs (Hard Reset)."
To go back up the hierarchy Press [
 ] ( : Back). About the control panelFor details on the control panel, see "Control Panel."
|
1
Press [ ] (: Settings), select [Network] using [ ] and [ ], and then press [OK].
] (: Settings), select [Network] using [ ] and [ ], and then press [OK].When the message is displayed, press [OK].
 |
You can specify the settings when the printer is either online (the
 (Online) indicator is on) or offline (the (Online) indicator is off). |
2
Select [Network Delay Time] using [ ] and [ ], and then press [OK].
] and [ ], and then press [OK].3
Specify the setting for startup waiting time using [ ] and [ ], and then press [OK].
] and [ ], and then press [OK].Set a delay of between 0 and 300 seconds from the time the printer is turned ON until it begins communicating.
4
Perform a hard reset or restart the printer.
After performing a hard reset or restarting the printer, the settings are effective.
|
NOTE
|
For details on a hard reset |