Initializing Using FTP Client

1
Run Command Prompt.
From the [Start] menu, select [All Programs] or [Programs] → [Accessories] → [Command Prompt].
2
Enter "ftp <the IP address of the printer>", then press the [ENTER] key on your keyboard.
Input Example: "ftp 192.168.0.215"
 If you are not sure about the IP address of the printer
Refer to Network Status Print ( "Checking the Printer Settings") or ask your network administrator.
3
Enter "root" as the user name, then press the [ENTER] key on your keyboard.
4
Enter the administrator password, then press the [ENTER] key on your keyboard.
If the administrator password is not specified yet, do not enter any value, but press the [ENTER] key on your keyboard.
5
Enter "get defaults", then press the [ENTER] key on your keyboard.
The defaults file (the list of the default values of the network settings) is downloaded.
6
Enter "put defaults CONFIG", then press the [ENTER] key on your keyboard.
7
Enter "get reset", then press the [ENTER] key on your keyboard.
After completing the reset, the network settings are initialized.
8
Enter "quit", then press the [ENTER] key on your keyboard.
9
Enter "exit", then press the [ENTER] key on your keyboard.
Command Prompt closes.