Restricting the Users Who Can Access

This section describes the procedure for specifying the settings using the Remote UI. To specify the settings using FTP Client, see "FTP Client."
NOTE
When restricted users access to print or perform some other operation
The message <Network Board Error> appears in the Printer Status Window.
1
Start the Remote UI, and then log in as Administrator.
2
Select [Information] from the [Device Manager] menu.
3
Click [Change] under [Security].
4
Select the [Restrict MAC Address Access] check box.
5
Select [Permit Specified Addresses] or [Reject Specified Addresses].
IMPORTANT
When [Permit Specified Addresses] is selected
You cannot access from an unauthorized MAC address. Therefore, confirm the MAC address when entering it.
If there is no corresponding MAC address, you cannot access the network. In this case, you can access the network by initializing the network settings.
6
Set the MAC address.
(1)
Enter the MAC address of a device for which you permit or reject accessing.
Enter 12-digit alphanumeric characters as 0123456789ab without separating them with "-" (hyphen) or ":" (colon).
You can set up to 20 MAC addresses.
(2)
Click [Add].
NOTE
When deleting a set MAC address
(1)
Select a MAC address you want to delete.
(2)
Click [Delete].
7
Click [OK].