Adjusting the Volume

The machine produces sounds in a variety of situations, such as when fax sending is complete or when a paper jam or error occurs. You can set the volume of each of these sounds individually.
1
Press (Volume Settings) on the operation panel.
2
Tap <Other Volume>.
To change <Fax Volume>, tap / or drag/flick the slider, and tap <Apply>.
Setting
Description and setting values
<Fax Volume>
Sound produced during a fax transmission
0 to 1 to 3
3
Tap a setting.
Setting
Description and setting values
Procedure
<Ring Tone>
Sound produced when an incoming fax is received
Go to step 4
0 to 1 to 3
<TX Done Tone>
Sound produced when fax sending is complete
Go to step 4
<Only When Error Occurs>  <On> (Sound is produced) or <Off> (No sound is produced) <Apply>
0 to 1 to 3 
<Only When Error Occurs>
<RX Done Tone>
Sound produced when fax receiving is complete
0 to 1 to 3
<Only When Error Occurs>
<Scanning Done Tone>
Sound produced when fax document scanning is complete
0 to 1 to 3
<Only When Error Occurs>
<Entry Tone>
Sound produced each time a key on the operation panel is pressed or an item on the display is tapped
<On> (Sound is produced) or <Off> (No sound is produced)
<Off>
<On>
<Invalid Entry Tone>
Sound produced when an invalid key operation is performed, such as when you enter a number outside the valid setting range or an invalid item is tapped on the display
<Off>
<On>
<Restock Supplies Tone>
Sound produced when a toner cartridge is almost empty
<Off>
<On>
<Warning Tone>
Sound produced when a paper jam or other error occurs
<Off>
<On>
<Job Done Tone>
Sound produced when an operation such as copying or scanning is complete
<Off>
<On>
<Energy Saver Alert>
Sound produced when the machine enters or exits sleep mode
<Off>
<On>
<Original in Feeder Detection Tone>
Sound produced when a document is loaded in the feeder
<Off>
<On>
4
Tap / or drag/flick the slider to adjust the volume, and tap <Apply>.
13U8-01A