IMPORTANT
|
Confirm the adjustment result.If any part of the print image lies outside the printable area after adjusting the printing position, the part will be missing in the print result.
|
NOTE
|
Adjustable areaYou can adjust the printing position between -50.0 mm and +50.0 mm for both the vertical direction and horizontal direction.
|
1.
|
Select [Offset Y] using [ ] and [ ], and then press [OK].
|
||
2.
|
Specify the target numeric value using [ ] and [ ], and then press [OK].
Each time you press [ ], the setting value increases by 0.5 mm, and each time you press [ ], the setting value decreases by 0.5 mm. Also, if you keep pressing [ ] or [ ] without releasing your finger, you can keep increasing or decreasing the value.
|
1.
|
Select [Offset X] using [ ] and [ ], and then press [OK].
|
||
2.
|
Specify the target numeric value using [ ] and [ ], and then press [OK].
Each time you press [ ], the setting value increases by 0.5 mm, and each time you press [ ], the setting value decreases by 0.5 mm. Also, if you keep pressing [ ] or [ ] without releasing your finger, you can keep increasing or decreasing the value.
|