NOTE
|
You need to complete some procedures before using fax functions. Configuring Initial Settings for Fax Functions
|
1
|
Enter the international access code.
![]() |
2
|
Use
![]() ![]() ![]() <p> (pause) is inserted between numbers. In this case, 012 will be dialed first, then two seconds later, the next number will be dialed.
NOTE:
Inputting pauses is optional; however, consecutive numbers that are input without pauses may not be recognized correctly.
Pauses can be inserted continuously.
One pause inserts 2 seconds of waiting time. This time can be changed as necessary. Set Pause Time
![]() |
3
|
Enter the country code, the area code, and the fax number.
![]() |
4
|
Select <Pause> to insert a pause at the end of the fax number as necessary, and press
![]() The waiting time inserted here is fixed to 10 seconds. This time cannot be changed.
![]() |
5
|
Press <Apply>.
![]() |
1
|
Use
![]() ![]() ![]() When there is only one page to be scanned, proceed to step 3.
|
2
|
Place the next document on the platen glass, and press
![]() Repeat this step until you finish scanning all of the pages.
|
3
|
Press <Start Sending>.
The faxes are sent.
|
TIPS
|
If you always want to send faxes with the same settings:
If you want to sound an alarm when the handset is off the hook:
If you want to check the dial tone before sending to avoid sending to wrong destinations:
|