Recalling Previous Settings and Sending a Fax

You can recall the three most recent destinations, scan settings, or send settings.

Press [Fax] → [Previous Settings].

Select the mode to set from the history → press [OK].

NOTE
You can change the settings for a recalled send job. If there are multiple destinations stored in one log, the order of the destinations shown in the list may not correspond to the order in which they were set.

IMPORTANT
Settings are counted as single groups of settings until the following times: When the power switch on the control panel is turned 'Off' When is pressed When is pressed When the Auto Clear mode activates When the Auto Sleep time has elapsed If you set [Manage Address Book Access Numbers] to 'On', you cannot recall settings from memory. (See "Managing the Address Book with Access Numbers.") If you set any address type to 'On' in [Limit New Destinations], the currently stored Previous Settings are deleted. (See "Restricting Sending to New Addresses.")

IMPORTANT

Settings are counted as single groups of settings until the following times:

When the power switch on the control panel is turned 'Off'

When

is pressed

When

is pressed

When the Auto Clear mode activates

When the Auto Sleep time has elapsed

If you set [Manage Address Book Access Numbers] to 'On', you cannot recall settings from memory. (See "Managing the Address Book with Access Numbers.")

If you set any address type to 'On' in [Limit New Destinations], the currently stored Previous Settings are deleted. (See "Restricting Sending to New Addresses.")

NOTE
The three most recent settings that were stored in memory are not deleted even when the main power is turned OFF.