Energy Consumption in the Sleep Mode

To "Settings/Registration Table."
You can set the amount of energy that the machine consumes when it is in the Sleep mode.
1.
Press (Settings/Registration).
2.
Press [Preferences] → [Timer/Energy Settings] → [Sleep Mode Energy Use].
3.
Specify the following settings → press [OK].
Details of each item are shown below:
[Low]:
Energy consumption in the Sleep mode is low, but it takes longer to recover from the Sleep mode.
[High]:
Energy consumption in the Sleep mode is high, but it takes less time to recover from the Sleep mode.
NOTE
If Sleep Mode Energy Use is set to 'Low', it may take more than 10 seconds for the touch panel to appear after pressing the control panel power switch.

NOTE
The energy consumption level is 'High' even when set to 'Low', depending on the status and type of installed MEAP applications.
If there are less than 10 minutes remaining before a Delayed Send job is to be sent, the energy consumption level is 'High' even when set to 'Low'.
If you are using a management application (such as NetSpot Console) to view or manage the settings and status of the machine via the network, the energy consumption level is 'High' even when set to 'Low'.
In some cases, the energy consumption level in the Sleep mode is 'High' even when the energy consumption level is set to 'Low'.
A job is being processed (including a forwarding job, report job, receive job, and sending a forwarding done notice).
A USB device is connected to the USB port.
If any of the following settings are set from the Settings/Registration screen:
Preferences
[Network]
[TCP/IP Settings]
<Use IPSec> is set to 'On'.
[NetWare Settings]
<Use NetWare> is set to 'On'.
[AppleTalk Settings]
<Use AppleTalk> is set to 'On'.
[Ethernet Driver Settings]
<Ethernet Type> is set to '1000Base-T'.
[IEEE802.1X Settings]
<Use IEEE802.1X> is set to 'On'.
[SMB Server Settings]
<Use SMB> is set to 'On'.
[WINS Settings]
<WINS Resolution> is set to 'On'.
[Function Settings]
[Send]
<Specify Print Time> for [Communication Management Report] is set to 'On'.*1
The <POP Interval> setting is set to 10 minutes or less in [E-Mail/I-Fax Settings] (except when the POP Interval setting is set to '0'.)
[Fax]
<Specify Print Time> for [FAX Activity Report] is set to 'On'. *1
[Receive/Forward]
[Set Fax/I-Fax Inbox]
A time limit for receiving fax documents in memory is set. *1
*1 If there are more than 10 minutes remaining before the specified time, the machine consumes the same amount of energy as when the energy consumption level is set to 'Low'.