Print & Check
This enables you to confirm scanned images page by page when you scan originals in succession on the platen glass. This is useful to prevent miscopying resulting from misscanning.
|
IMPORTANT
|
|
Place your original on the platen glass. You cannot copy using the Print & Check mode with the originals set in the feeder.
|
1.
Press [Copy].
2.
Press [Options] → [Print & Check] → [Close].
3.
Press 
(Start).
(Start).Check the content of the output.
To copy the next original, place your original → press (Start) again.
(Start) again.To rescan an original immediately after scanning, reset the original → select [Re-Scan] → press (Start).
(Start).If you want to change the scan settings, press [Change Settings]. If you want to change the settings, change them before pressing (Start).
(Start).Scan the originals until they are all scanned. Press [Start Copying] to start copying.
|
NOTE
|
|
To cancel scanning, press [Stop] or
 (Stop). |
|
IMPORTANT
|
|
For information on the modes which cannot be set in combination with this mode, see "Combination of Functions Chart."
When [1-Sided
 2-Sided] is set, two-sided copying is not performed and the machine copies one original at a time. |