2 on 1/4 on 1

You can reduce multiple documents to copy them onto one sheet.
<2 on 1>
Reduce two-page documents to fit on one sheet of paper.
    
<4 on 1>
Reduce four-page documents to fit on one sheet of paper.
Select <Select Layout> to change layout of the copy.
NOTE
Combine functions:
You can use 2 on 1/4 on 1 together with the following functions.
"Adjusting the Density"
"Selecting the Original Type"
"Enlarging/Reducing Copies"
"Collating Copies"
When <2 on 1> or <4 on 1> is selected, copy ratio is automatically set to fit multiple documents on a single page.
To manually adjust the copy ratio, select <2 on 1> or <4 on 1>, and then select <Copy Ratio>.
1
Place documents.
"Placing Documents"
"Supported Document Types"
2
Display the Copy mode screen.
Press [] (COPY/SCAN) to switch to the Copy mode screen.
3
Press [] or [] to highlight <N on 1: Off>, and then press [OK].
4
Press [] or [] to highlight <2 on 1> or <4 on 1>, and then press [OK].
To specify the layout:
(1)
Press [] or [] to highlight <Select Layout>, and then press [OK].
(2)
Press [] or [] to highlight the layout, and then press [OK].
NOTE
Margins among documents:
When you copy in an N on 1 layout, margins are created among the reduced documents.
5
Press [] or [] to highlight the size of the original document, and then press [OK].
6
Press [] or [] to highlight the size of the output document, and then press [OK].
7
Press [] (Start).
When your document is placed on the platen glass:
(1)
Set the next document and press [] (Start).
Repeat these steps until all documents are scanned.
(2)
Press [] or [] to highlight <Finish Scanning>, and then press [OK].
0H88-01Y