Manual Feeder Cleaning(imageRUNNER 2202N/2002N Only)

If your originals have black streaks or appear dirty after copying them using the feeder, this may be caused by pencil writing rubbing off the originals and onto the roller. Perform this feeder cleaning procedure to clean the feeder scanning area, film, and roller.
WARNING
When cleaning the machine, first turn OFF the main power switch and disconnect the power cord. Failure to observe these steps may result in a fire or electrical shock.
IMPORTANT
Do not dampen the cloth too much, as excess water may damage the machine.
If the feeder scanning area is dirty, it may result in a paper jam or smudged or dirty prints.
Clean the roller while spinning it with your hand.
NOTE
This procedure is necessary only when the optional feeder (DADF-AM1) is attached to the imageRUNNER 2202N/2002N.
1
Open the feeder cover.
2
Clean the rollers (a total of three places) inside the feeder cover with a cloth dampened with water. Then wipe the area with a soft, dry cloth.
3
Open the inner cover, holding it by its front tab.
4
Clean the rollers (a total of three places) inside the inner cover with a cloth dampened with water. Then wipe the area with a soft, dry cloth.
5
Clean the transparent plastic part of the inner cover with a cloth dampened with water. Then wipe the area with a soft, dry cloth.
6
Close the inner cover.
CAUTION
When closing the inner cover, be careful not to get your fingers caught, as this may result in personal injury.
7
Close the feeder cover.
CAUTION
When closing the feeder cover, be careful not to get your fingers caught, as this may result in personal injury.
8
Lift the feeder.
9
Clean the feeder scanning area (the left side of the platen glass) and the document feeding roller, with a cloth dampened with water. Then, wipe the area with a soft, dry cloth.
* Document Feeding Roller
* Feeder Scanning Area
10
Close the feeder.
CAUTION
When closing the feeder, be careful not to get your fingers caught, as this may result in personal injury.
0FJJ-0E4