Configuring Ethernet Settings

 
Ethernet is a standard for communicating data in a local area network (LAN). You can set the communication mode (half-duplex/full-duplex) and the Ethernet type (10BASE-T/100BASE-TX/1000BASE-T). In general, the machine can be used without changing the defaults (Ethernet Driver Settings), but you can change these settings to suit your network environment.
1
Press .
2
Use / to select <Network Settings>, and press .
If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press . Logging on to the Machine
3
Select <Ethernet Driver Settings> <Auto Detect>.
4
Select whether to configure Ethernet settings automatically or manually.
Configuring Ethernet settings automatically
Select <On>, and press . The machine detects and automatically sets the communication mode and the Ethernet type that can be used.
Configuring Ethernet settings manually
1
Select <Off>, and press .
2
Select the communication mode.
Select <Communication Mode>    select <Half Duplex> or <Full Duplex>  .
 <Half Duplex>
Alternately sends and receives communication data. Select when the machine is connected to a networking device using half duplex.
 <Full Duplex>
Simultaneously sends and receives communication data. Use this setting for most environments.
3
Select the Ethernet type.
Select <Ethernet Type>    select <10BASE-T> , <100BASE-TX> or <1000BASE-T>  .
4
Press .
5
Restart the machine.
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
0RCJ-06L