Setting Job Suspension for Detection of Multi-Sheet Feeding
Multi-sheet feeding refers to feeding of multiple sheets of paper at a time from the paper feeding section. This setting enables you to set the machine to suspend the job when multi-sheet feeding is detected.
IMPORTANT |
Depending on the size of paper or operation mode of the machine, paper may remain inside the machine. In this case, the job may not be restarted automatically. |
1.
Press 
(Settings/Registration).
(Settings/Registration).2.
Press [Function Settings] → [Common] → [Paper Feed Settings].
3.
Press [Suspend Job When Multi. Sheet Feed Detected].
4.
Select [On] or [Off], → press [OK].
Details of each item are shown below:
[On]: The job is suspended when multi-sheet feeding is detected, and a message will be shown. Check the paper and output results, and then restart printing according to the message.
[Off]: When the optional POD Deck-D1 is installed, any unnecessary paper is output to the escape tray and the job is restarted automatically. If not installed, the job is suspended and a message will be shown. Remove jammed paper according to the message.
[On]: The job is suspended when multi-sheet feeding is detected, and a message will be shown. Check the paper and output results, and then restart printing according to the message.
[Off]: When the optional POD Deck-D1 is installed, any unnecessary paper is output to the escape tray and the job is restarted automatically. If not installed, the job is suspended and a message will be shown. Remove jammed paper according to the message.
IMPORTANT |
When set to "Off", because detected paper is output to the escape tray, the following pages may become out of order and incorrect output may be produced. |