IMPORTANT
|
If you are configuring the interface settings for the first time, use the machine’s control panel. After configuring the protocol settings, you can change the content by using the Remote UI. For instructions, see Using the Remote UI.
Changes made to Interface Settings become effective when the machine is restarted. To restart the machine, turn it OFF, wait at least 10 seconds, and then turn it ON. For instructions on how to turn the machine ON and OFF, see Chapter 2, “Before You Start Using the Machine,” in the User’s Guide.
|
1
|
Press [On] for <Auto Detect>.
|
1
|
Press [Off] for <Auto Detect>.
|
2
|
Press [Half Duplex] or [Full Duplex] for <Communication Mode>.
|
3
|
Press [Full Duplex] if you want to alternately send and receive. Press [Half Duplex] if you want to simultaneously send and receive.
|
4
|
Press [10 Base-T] or [100 Base-TX] for <Ethernet Type>.
|