When the punch waste tray of the External 2/3 Hole Puncher-C1 becomes full, an animation screen prompting you to remove the punch waste appears on the touch panel display.
The location of the External 2/3 Hole Puncher-C1 is indicated in the following illustration.
Removing Punch Waste (External 2/3 Hole Puncher-C1)
NOTE |
The External 2/3 Hole Puncher-C1 is optional products. The External 2/3 Hole Puncher-C1 is available only when the Staple Finisher-T1 or Booklet Finisher-T1 is attached. |
1.
Pull out the punch waste tray.
2.
Discard the punch waste.
NOTE |
Make sure that the punch waste tray is completely emptied. |
3.
Return the punch waste tray to its original position.
 | 1. Push the punch waste tray back into its original position. |
2. Close the front cover of the puncher. |
 CAUTION |
When closing the cover, be careful not to get your fingers caught, as this may result in personal injury. |
NOTE |
If the punch waste tray is not securely in place, you cannot make copies or prints in the Hole Punch mode. |