Specifying IP Addresses for Firewall Rules

You can either limit communication to only devices with specified IP addresses, or block devices with specified IP addresses but permit other communications. You can specify a single IP address or a range of IP addresses. For data reception, you can specify IP addresses by specifying port numbers.
Up to 16 IP addresses (or ranges of IP addresses) can be specified for both IPv4 and IPv6.
The maximum number of port numbers that can be specified for a single IP address is 50.
The packet filters described in this section control communications over TCP, UDP, and ICMP.
1
Start the Remote UI and log on in Management Mode. Starting Remote UI
2
Click [Settings/Registration].
3
Click [Security]  [IP Address Filter].
4
Click [Edit] for the filter type that you want to use.
[IPv4 Address: TX Filter]
Select to restrict sending data from the machine to a computer by specifying IPv4 addresses.
[IPv4 Address: RX Filter]
Select to restrict receiving data from the machine to a computer by specifying IPv4 addresses and the port number.
[IPv6 Address: TX Filter]
Select to restrict sending data from the machine to a computer by specifying IPv6 addresses.
[IPv6 Address: RX Filter]
Select to restrict receiving data from the machine to a computer by specifying IPv6 addresses and the port number.
5
Specify the settings for packet filtering.
For TX Filter
For RX Filter
6
Perform a hard reset.
Click [Device Control], select [Hard Reset], and then click [Execute].
The settings are enabled after the hard reset is performed.
Using the operation panel
You can also enable or disable IP address filtering from the Setting menu of the operation panel. Address Filter
0YS1-045