Setting Up Connection Using WPS Push Button Mode

If your wireless router supports WPS push button mode, you can easily set up a connection with a WPS button.


How to operate the wireless router may vary on each device. See the instruction manuals for your networking device for help.

Tap <Menu> in the Home Screen.

Tap <Network Settings>.

If a screen for entering a System Manager ID and PIN is displayed, enter the System Manager ID and PIN, tap <Apply>, and press

. Setting the System Manager ID

Tap <Wireless LAN Settings>.

If the <Do you want to enable the wireless LAN?> message is displayed, tap <Yes>.

Read the message that is displayed, and tap <OK>.

Tap <WPS Push Button Mode>.

Tap <Yes>.

Press and hold the WPS button on the wireless router.

The button must be pressed within 2 minutes after tapping <Yes> in step 6.

Depending on the networking device, you may need to press and hold the button for 2 seconds or longer. See the instruction manuals for your networking device for help.

If an error message is displayed during setup
Tap <Close> and return to step 5.

Check that the Wi-Fi indicator is blinking on the operation panel.

The Wi-Fi indicator blinks when a wireless router is detected.

When the setup is completed, the screen below is displayed, and approximately 2 seconds later, the Wi-Fi indicator lights up.

Wait approximately 2 minutes until the IP address settings of the machine are completed.

Signal strength

When more than one wireless router is available for connection, the machine connects to the device with the strongest signal. Signal strength is measured using RSSI (Received Signal Strength Indication).


Reducing power consumption You can set the machine to enter <Power Save Mode> based on signals emitted from the wireless router. Power Save Mode If the IP address of the machine has changed In a DHCP environment, the IP address of the machine may be changed automatically. If this happens, the connection is maintained as long as the machine and the computer belong to the same subnet.

Reducing power consumption

You can set the machine to enter <Power Save Mode> based on signals emitted from the wireless router. Power Save Mode

If the IP address of the machine has changed

In a DHCP environment, the IP address of the machine may be changed automatically. If this happens, the connection is maintained as long as the machine and the computer belong to the same subnet.

Connecting to a Wireless LAN