Staple Finisher-Z

Installing "Staple Finisher-Z" enables you to use the following finish functions.

Collate
The printouts are collated into sets arranged in page order of the original.

Group
All printouts of the same original page are grouped together into sets.

Offset
Each printout group is shifted in alternating layers.

Staple + Collate
The printouts are collated into sets arranged in page order and stapled (Corner).

Output tray

The prints are output to this tray.

Front cover

Open to remove jammed paper, clear a staple jam in the stapler unit, or replace the staple cartridge.

Buffer Pass Unit

Open to remove jammed paper.

Selecting the Staple Position

To finish with the stapler, you need to select the staple position paying attention to the orientation of original document.

NOTE
For the procedure to finish with the stapler, see Finishing with the Stapler.

Stapling at One Location in a Corner of the Paper (Corner)

Refer to the following figures to select the staple position.

Stapling at the top right of paper in portrait orientation

	Feeder		Platen glass

select <Top Left>

Stapling at the top left of paper in portrait orientation

	Feeder		Platen glass

select <Bottom Left>

Stapling at the top right of paper in landscape orientation

	Feeder		Platen glass

select <Top Right>

Stapling at the top left of paper in landscape orientation

	Feeder		Platen glass

select <Top Left>


For information on the paper sizes that can be used for Staple, see Hardware Specifications. To replace the staple cartridge of the stapler unit, see Replacing the Staples (Optional). For how to clear a paper jam or a staple jam, see Clearing Paper Jams and Clearing Staple Jams (Optional). Once the output tray reaches its stacking limit while going down or reaches the lower end of travel, printing is suspended. Remove all of the output paper from the tray to resume printing. Collate and group If you select <Offset> in combination with the collate or group function, each printout group is shifted. Staplers When you are using the Staple mode, do not remove the stack of paper from the output tray during the job. Remove the stack of paper when the job has been completed. If the <Load staples into the stapler unit.> message appears, almost all of the staples have been used. To proceed, replace the staple cartridge.

For information on the paper sizes that can be used for Staple, see Hardware Specifications.

To replace the staple cartridge of the stapler unit, see Replacing the Staples (Optional).

For how to clear a paper jam or a staple jam, see Clearing Paper Jams and Clearing Staple Jams (Optional).

Once the output tray reaches its stacking limit while going down or reaches the lower end of travel, printing is suspended. Remove all of the output paper from the tray to resume printing.

Collate and group

If you select <Offset> in combination with the collate or group function, each printout group is shifted.

Staplers

When you are using the Staple mode, do not remove the stack of paper from the output tray during the job. Remove the stack of paper when the job has been completed.

If the <Load staples into the stapler unit.> message appears, almost all of the staples have been used. To proceed, replace the staple cartridge.